Residual antibacterial activity was determined by a disk diffusion assay against P. aeruginosa. The effect of pH was determined using a pH range from 2 to 10 with diluted HCl or NaOH. After incubation for 2 h at 25 °C and neutralization to pH 7, the residual activity was tested. Resistance to proteases was tested by incubating Seliciclib S07-2 compound with proteinase K, trypsin or α-chemotrypsin at ratios of 1 : 10 and 1 : 5 (w/w) as described previously (Tabbene et al., 2009a). MS experiments were carried out using a prOTOFTM instrument (Perkin-Elmer) operating in the reflectron mode and with an accelerating voltage
of 16 kV. The matrix used was α-cyano-4-hydroxycinnamic acid. The instrument was calibrated with peptides of known molecular mass in the 1000–2500-Da range (PepMix1, LaserBiolabs, France). In typical measurements, the mass accuracy was ±5 p.p.m. The MIC of the S07-2 compound on different bacterial strains was determined by microbroth dilution assay. Twofold increasing concentrations of the selleck chemicals llc sample (from 3.9 to 1000 μg mL−1) were tested on cell suspensions (106 CFU mL−1) in LB medium. Control wells with 20% methanol were included. Plates were incubated at 37 °C
for 24 h. Bacterial growth was determined by measuring the OD600 nm using a microplate reader (Bioteck, ELx 800). MIC was defined as the lowest concentration inhibiting bacterial growth. MBC was determined from the same experiments by removing 10 μL from wells without growth after 48 h of incubation. These aliquots were then spread onto LB agar plates for counting. MBC was defined as the lowest concentration causing 95% killing of the microbial population. The hemolytic activity of the S07-2 compound on human erythrocytes was also determined (Mangoni et al., 2000). Briefly, blood was centrifuged AMP deaminase and erythrocytes were washed three times with 0.9% NaCl. Increasing concentrations of the sample, ranging from 3.9 to 1000 μg mL−1, were incubated with the erythrocyte suspension (1 × 107 cells mL−1 in 0.9% NaCl) at 37 °C for 30 min. The extent of hemolysis was measured at 415 nm. Hypotonically
lysed erythrocytes were used as a standard for 100% hemolysis. The S07-2 compound was subjected to chemical assays, to investigate its siderophore nature. Catecholate-, hydroxamate- and carboxylate-type siderophores were measured according to Arnow (1937), Neilands (1981) and Shenker et al. (1992), respectively. Fe2+-chelating activity was evaluated according to Moktan et al. (2008). Twofold increasing concentrations of the S07-2 compound (0.24–125 μg mL−1) were added to 0.5 mM ferrous chloride tetrahydrate solution. After a 5-min incubation at room temperature, 1.25 mM ferrozine was added. The mixture was incubated for 10 min at room temperature and the A562 nm was measured. EDTA was used as a positive control.