The values of the intensity ratios shown between parentheses were obtained from the Raman spectra of CNTs on the electrodes, while values outside parentheses were taken in between the electrodes. The obtained local intensities of the G+ band are displayed in the Raman map shown in Figure 5. The I D/I G ratio for CNT bundles between the electrodes and on the electrodes DMXAA order is shown in the mapping of Figure 6. The I D/I G ratio appears similar for different excitation wavelengths having a value of 0.29 ± 0.02 for CNTs on the bundles between the electrodes and a I D/I G ratio of 0.30 ± 0.01 for

CNTs on the electrode. The shape of the three peaks (D, G+, and G−) does not change throughout the investigated region. Given that the Raman imaging shows a homogeneous CNT quality along the FET, differences in resistance observed by CS-AFM between different bundles can most certainly be attributed to the quality of the Pd electrode/CNT contact, and not to the CNT quality. A slightly higher defect concentration observed at the CNTs on the electrodes might come from welding of the CNT onto the Pd electrode during deposition, although such small difference in I D/I G ratio is within the experimental error. Conclusions Raman spectroscopy and imaging Trichostatin A ic50 in addition to current sensing AFM were used in order to investigate

a CNT-based device. Semiconducting single-walled CNTs were deposited and aligned using dielectrophoresis. The semiconducting character of the CNT bundles was proved by Raman spectroscopy, and the SWCNT diameter was determined to be 2.5 ± 0.3 nm. It is shown that an Ohmic contact between the palladium electrodes and the CNTs is realized using this fabrication method without any significant increase in

defect density at the GABA Receptor CNT/electrode contact. Acknowledgments The work is supported by the following projects: DFG Research Unit 1713 ‘Sensorische Mikro- und Nanosysteme’ and DFG project ZA146/22-1 Raman investigations of In(Ga)As/Al(Ga)As self-assembled quantum dot structures: from ensembles to single quantum dots’. Alexander Villabona is acknowledged for the implementation of the stage for Raman imaging. We also acknowledge the staff of the ZfM for the help with structure fabrication and SEM measurements. References 1. Hueso LE, Pruneda JM, Ferrari V, Burnell G, Valdes-Herrera JP, Simons BD, Littlewood PB, Artacho E, Fert A, Mathur ND: Transformation of spin information into large electrical signals using carbon nanotubes. Nature 2007, 445:410–413.CrossRef 2. Kuemmeth F, Ilani S, Ralph DC, McEuen PL: Coupling of spin and orbital motion of electrons in carbon nanotubes. Nature 2008, 452:448–452.CrossRef 3. Sgobba V, Guldi DM: Carbon nanotubes-electronic/electrochemical properties and application for nanoelectronics and photonics. Chem Soc Rev 2009, 38:165–184.CrossRef 4.