Under the lower machining speeds of 25 and 100 m/s, the chip formation is more like a material pile-up process, and the regular flow of the material along the tool rake #selleck chemical randurls[1|1|,|CHEM1|]# face cannot be observed. Also, for these two lower speed cases, the stress concentration along the primary shear zone is more significant than that along the secondary shear zone. Therefore, chip formation seems to be very sensitive to the machining speed for nano-scale polycrystalline machining – the regular uniform
chip can only be formed at high machining speeds of more than 100 m/s. In addition, it can be found that lower machining speeds reduce the maximum equivalent stress value. For instance, at the tool travel distance of 240 Å, the maximum equivalent stresses are 42.7, 31.2, and 30.1 GPa at the machining speeds of 400, 100, and 25 m/s, respectively. Figure 9 Chip formations and equivalent stress distributions in nano-scale polycrystalline machining for case C8. At the tool travel distances of (a) 30, (b) 120, and (c) 240 Å. Figure 10 Chip formations and equivalent stress distributions in nano-scale polycrystalline machining for case C9. At the tool travel distances of (a) 30, (b) 120, and (c) 240 Å. VX-680 price By comparing the
cutting force results shown in Figure 11 and Table 6, it is observed that higher machining speeds constantly introduce higher tangential forces, while the increase of thrust force flats out after the machining speed exceeds 100 m/s. Overall, as the machining speed increases from 25 to 400 m/s, the tangential force increases from 339.85 to 412.16 eV/Å and the thrust force increases
from 257.03 to 353.59 eV/Å. Figure 11 Evolution of cutting forces at the machining speeds of 25, 100, and 400 m/s. (a) Tangential force, F x and (b) thrust force, F y . Table 6 Average cutting force values with respect to machining speed Case number Machining speed (m/s) F x (eV/Å) F y (eV/Å) F x /F y C4 400 412.16 353.59 1.17 C8 100 358.08 355.02 1.01 C9 25 339.85 257.03 1.32 Effect of grain size Cutting force and equivalent stress distribution We first investigate the effect of grain size on cutting forces in machining polycrystalline structures. Figure 12 shows the evolution of cutting force components for cases C2 to C7, which represent six polycrystalline structures (i.e., 16.88, Dichloromethane dehalogenase 14.75, 13.40, 8.44, 6.70, and 5.32 nm, respectively, in terms of grain size). For benchmarking, the case of monocrystalline machining, namely, case C1, is also added to the comparison. Similarly, the average F x and F y values are obtained from the period of tool travel distance of 160 to 280 Å for these cases, and the results are shown in Figures 13 and 14. It is clear that the overall magnitudes of both F x and F y for monocrystalline machining are higher than any of the polycrystalline cases. The average F x and F y values for case C1 are 470 and 498 eV/Å, respectively.