13 The skin irritation study was carried out by using healthy rabbits

(n = 3). The evaluation was based on scoring method described by Draize et al, where the scores are assigned from 0 to 4 based on the severity of erythema or oedema. 14 Statistical analysis were performed using the SPSS-18.0 package. The ex vivo permeation results obtained were tested statistically using one-way analysis of variance (ANOVA). Post-hoc Tukey-HSD (Honestly Significant Difference) test was performed when there was a statistically significant difference, which was considered at p < 0.05. In the present study, altogether eight different formulations FG-4592 research buy were prepared by varying the polymer ratio and permeation enhancers. The weight of the patches varied from 0.0095 to 0.0131 g (±0.0002 to ± 0.0009) (Table 2) while the thickness of the patches ranges from 0.0533 to 0.1267 mm (±0.006 to ± 0.012)

(Table 2). The results indicate the physical uniformity of the prepared patches. The minimal SD values shows that the process used for preparing the patches is capable of formulating patches with minimum intra batch variability. The folding endurance value was found to be >280, was observed in all batches. This indicates that the prepared patches have good tensile strength, flexibility, RG7204 research buy capable to withstand the mechanical pressure and able to maintain the integrity with general skin folding when applied. The drug content were found to be uniform throughout the formulated patches with the minimum SD values (±0.012 to ± 0.057), assuring the process adopted to prepare the patches is capable

of giving reproducible results. The percentage moisture absorption was calculated from the weight difference relative to the initial weight after exposing the formulated patches to 85% RH. It was found that the formulations containing aloe vera as the penetration Bumetanide enhancer had higher rates of moisture absorption than formulations containing menthol. The formulation coded as F1 had the highest moisture absorption rates 5.24%, where as F2 and F4 had shown the lowest moisture absorption rates of 1.37% and 1.34% respectively. The highest percentage moisture absorption of F1 can be attributed to the higher polydispersity index and solubility parameter of HPMC. In addition to that, the percentage of moisture absorption was found to increase with the increasing concentrations of PEG 400. Overall, the moisture absorption of the formulations were low, which could protect the formulations from microbial contamination and reduce bulkiness. The FTIR spectra of captopril and formulated patches were illustrated in Fig. 3, Fig. 4 and Fig. 5. In the IR spectrum of captopril, the peak at 2979.83 cm−1 was assigned to the asymmetric CH3 stretching vibration, peak at 2565.75 cm−1 corresponds to the SH stretching vibration due to the presence of thiol group. The characteristic band at 1748.04 and 1589.