The pTAP and pTP constructs were introduced into E.

coli DH5α by electroporation using a Gene Pulser (BioRad) with settings of 2.5 kV and 25 μF. Recombinants were selected for ampicillin resistance and clones were screened for the presence of the gentamicin resistance gene using the oligonucleotide primers GmF and GmR. Selected clones were cultured in larger volumes and plasmid DNA extracted using a Midi prep kit (Qiagen) according to the manufacturer’s instructions. Transformation of M. gallisepticum M. gallisepticum was transformed by electroporation as described previously [39, 40]. Following electroporation, cells were gently resuspended in 1 ml of ice-cold MB, incubated at 37°C to allow expression of the gentamicin resistance LY3039478 gene, then a 500 μl aliquot of the culture inoculated onto MA plates containing 16 μg of gentamicin/ml, which were allowed to dry and then incubated at 37°C for 4 days. The plates were examined

for colony VX-689 order development and single colonies selected and subcultured in MB containing 16 μg of gentamicin/ml. Detection of alkaline phosphatase activity on MA plates To detect alkaline phosphatase activity in colonies of transformed M. gallisepticum on MA plates, a single tablet of BCIP/nitroblue tetrazolium (NBT) (Sigma Fast, Sigma) was dissolved in 3 ml distilled water and sprayed onto the colonies uniformly as a thin layer using a pump atomizer. After 10 min colonies were observed for the presence of a blue colour. Genomic DNA sequencing To determine the insertion site of the transposon, genomic DNA Endonuclease sequencing was carried out selleck chemicals llc using the ABI Prism BigDye Terminator v3.1 (BDT) sequencing system (Perkin Elmer Applied Biosystems) and the UBR oligonucleotide primer (Table 1) according to the manufacturer’s instructions, with minor modifications. Approximately 2 μg of genomic DNA was combined with 1 μM of the UBR oligonucleotide, 4 μl of the

BDT enzyme mixture, 4 μl of 5 x BDT buffer and distilled water to 20 μl. The sequencing reaction mixture was incubated at 96°C for 5 min, then through 60 cycles of 96;°C for 30 s, 50°C for 10 s and 60°C for 4 min in an iCycler thermocycler (BioRad). The sequencing products were purified according to the manufacturer’s instructions using ethanol-EDTA-sodium acetate precipitation and analysed using an ABI3100 capillary sequencer. Quantitative RT-PCR Quantitative RT-PCR (qRT-PCR) was used to determine the level of transcription of the phoA gene in each of the transformants. To achieve this, total RNA from 6 ml of transformant cells was extracted using an RNA purification kit (Qiagen), following the manufacturer’s instructions. The total amount of RNA was determined using an ND-1000 spectrophotometer (NanoDrop). To remove any contaminating DNA, 2 μg of extracted RNA was treated with 2 U of DNase I (Invitrogen) in a buffer containing 2 μl of 10 x DNase I buffer and RNase-free water in a total volume of 20 μl for 15 min at room temperature.